Filter
Top Products
31
Auto SP/EP Timer
If, when recording in SP mode, there is not enough tape to
record the entire program, the VCR automatically switches to EP
mode to allow complete recording. This feature is especially
handy when recording a program of more than 2 hours in
length.
For Example . . .
Recording a program of 140 minutes in length onto a 120-
minute tape
Make sure you select “ON” at the Auto SP/EP Timer screen
before performing timer programming.
Approximately 110 minutes
SP mode
ACCESS MAIN MENU
SCREEN
1
Press MENU as many times as necessary.
ACCESS FUNCTION SET
SCREEN
2
Place the arrow next to "FUNCTION SET" by pressing
CH
5
∞ or PUSH JOG
5
∞, then press OK.
ACCESS AUTO SP/EP
TIMER SCREEN
3
Place the arrow next to “AUTO SP/EP TIMER” by
pressing CH
5
∞ or PUSH JOG
5
∞, then press OK.
SELECT MODE
4
Place the arrow next to
your choice (“ON” or
“OFF”) by press CH
5
∞ or
PUSH JOG
5
∞.
RETURN TO NORMAL
SCREEN
5
Press MENU as many times as necessary.
NOTES:
●
If you have programmed the VCR to timer-record 2 or more
programs, the second program and those thereafter may not
fit on the tape if you set the Auto SP/EP Timer mode to "ON".
In this case, make sure the mode is not engaged, then set the
tape speed manually during timer programming.
●
There may be some noise at the point on the tape where the
VCR switches from SP to EP mode.
●
The Auto SP/EP Timer feature is not available during ITR
(Instant Timer Recording), and the feature will not work
properly with any tapes other than the following: T-30, T-60,
T-90, and T-120.
AUTO SP/EP TIMER
=ON
OFF
PRESS (5,∞) TO SELECT
PRESS (MENU) TO END
Approximately 30 minutes
EP mode
Total 140 minutes
12
45
3
6
8
0
7
9
∞ 5
6
q
PUSH JOG
OK
MENU
CH
MENU
OK
CH