Filter
Top Products
14
PLAYBACK (cont.)
12
45
3
6
8
0
7
9
2
1
3
8
••
•
•
••
••
•
•
•
••
•
•
••
••
•
•
•
REW
OPERATE
C. MEMORY
FF
Next Function Memory
You can set your recorder's power to go off automatically after
the tape is fully rewound. Before starting, make sure the
recorder is in the Stop mode.
For Automatic Power Off After Tape Rewind . . .
. . . press REW, then press OPERATE within 2 seconds.
NOTE:
If you want the power to be turned off automatically when the
counter reads “0:00:00” (instead of at the beginning of the
tape), press C.MEMORY so that the “M” mark appears before
pressing REW.
Tape Position Indicator
The tape position indicator appears
on screen when, from the Stop
mode, you press FF, REW or
perform an Index Search. The
position of “5” in relation to “0”
(beginning) or “+” (end) shows you
where you are on the tape.
”On-Screen” (੬ pg. 23) must be
set to “ON”, or the indicator will
not appear.
NOTE:
Depending on the type of tape used, there may be times when
the indication is not correct.
0
+++
3
1:23:45
REMAIN 2:35
FF
REW
PUSH JOG
OPERATE
Index Search
Your recorder automatically marks
index codes at the beginning of
each recording. This function gives
you quick access to any one of 9
index codes in either direction.
NOTE:
Before starting, make sure the
recorder is in the Stop mode.
ACTIVATE INDEX SEARCH
1
Press PUSH JOG or (™ or £). “™ 1” or
“£ 1” is displayed on screen and search begins in
the corresponding direction.
● To access index codes 2 through 9, press PUSH JOG
or repeatedly until the correct index number is
displayed.
Ex.: To locate the beginning of B from the current
position, press PUSH JOG twice.
To locate the beginning of D from the current
position, press PUSH JOG once.
● When the specified index code is located, playback
begins automatically.
£ 2
Current position
Index number
%
fi
%
fi
fi
%
AB C D E F
–2 –1 1 2 3