Filter
Top Products
30
Regular Timer
Programming
If you don’t know the PlusCode number for the programme you
wish to record, use the following procedure to set your recorder
to timer-record the programme.
Or you can use the Illumi-Guide feature, where the remote
control tells you which button to press next by lighting it up. To
use the Illumi-Guide feature, press ILLUMI GUIDE before
performing step 1. (PROG, REW, PLAY, FF light up at this time.)
If you aren't going to use the Illumi-Guide feature, go directly to
step 1.
5
8
0
7
9
1
3
START+/–
PROG.
2,3
1
When Using The Illumi-Guide Feature
● Buttons light or blink on the remote control for
approximately 10 seconds. If the button or buttons extinguish
during timer programming, press ILLUMI GUIDE and the
button or buttons previously lit or blinking come back on. If
the button or buttons do not re-light or start blinking again,
press CANCEL and re-perform the timer programming
procedure from the beginning.
● If for some reason the remote control's signal is not received
by the video recorder, press CANCEL and re-perform the
timer programming procedure from the beginning.
TIMER RECORDING(cont.)
CANCEL
ILLUMI GUIDE
Remember, the clock must be set before you can progamme
the timer (੬ pg. 9).
ACCESS TIMER PROGRAM-
MING SCREEN
1
Press PROG.
● If you are using the Illumi-Guide feature, the following
buttons will light up: NUMBER keys (0–9), START +/–,
STOP +/–, DATE +/–, TV PROG +/–, and CANCEL.
ACCESS PROGRAMME
SCREEN
2
Press START +/–. (If you’re
just starting out, “Program
1” appears.)
The front display panel looks like this:
● If you are using the Illumi-Guide feature, the following
buttons will light up: START +/–, STOP +/–, DATE +/–,
and TV PROG +/–.
ENTER PROGRAMME
START TIME
3
Press START +/– to enter
the time you want
recording to start.
● Press and hold START
+/– to move in 30-
minute increments, or
press and release
repeatedly to move 1
minute at a time.
The front display panel looks like this:
● If you are using the Illumi-Guide feature, the following
buttons remain lit: START +/–, STOP +/–, DATE +/–,
and TV PROG +/–.
SP
SP
PROGRAM 1
START STOP
– : – – – : – –
SP
ON
DATE TV PROG
25. 12 – –
[+ –] : SET =
:OK
PROGRAM 1
START STOP
21 : 00 – : – –
SP
ON
DATE TV PROG
25. 12 – –
[+ –] : SET =
:OK
Before performing the following steps:
● Insert a cassette with the safety tab in place. The recorder
will come on automatically.
● Turn on the TV and select the VIDEO preset (or AV mode).
8
••
•
•
••
••
•
•
•
••
•
•
••
••
•
•
•