Filter
Top Products
EN 55
This Remote is capable of transmitting two control
codes; one set to respond to A code control signals and
another set to respond to B code control signals.
This Remote control is preset to send A code signals
because your VCR is initially set to respond to A code
signals. You can easily modify your VCR and the Remote
to respond to B code signals.
When using two JVC VCRs, set two VCRs and their
Remotes to different codes, so that you can operate these
VCRs separately.
Set remote control code for Remote
Press and hold A/B.
Press the Number key “2”.
Press OK, and release A/B.
● The Remote now can transmit B code control
signals.
Check remote control code for VCR
Press and hold 3 on the VCR for more than
5 seconds while the VCR is turned off. The code
currently set appears on the display panel.
Change code for VCR
Press any key on the Remote.
● The VCR now responds to B code control
signals.
● To set the Remote and the VCR back to A code
control signals, repeat the same procedure as
shown above except pressing the Number key
“1” in step of .
To control two VCRs with the same Remote
You can control two JVC VCRs by switching the remote
control code for the Remote between A and B (੬ step
), keeping two VCRs to different control codes.
● Press the Number key “1” for A code control signals
and the Number key “2” for B code control signals. (To
change only the remote control code for the Remote,
DO NOT perform steps and .)
Changing
Remote Control
Code
(Ex.) To set Remote to B code:
Press in succession
Hold
down
Release
123
456
7
89
0
2
4
1
3
–
–
– ,
MBRSET
A/B
2
OK
3
E
N
T
E
R
/
O
S
D
VIDEO (MONO)L—AUDIO—R
S VIDEO
S-VHS ET
FF
REW
POWER
REC PAUSE STOP/EJECT
PLAY
–
+
CH– /+
PUSH / TURN
24HR QUICK
PROGRAM
REC LINK
A.DUB
INSERT