Filter
Top Products
Masterpage:Right-No-Heading
EN 29
Filename [XV3EX_07S-VHS.fm]
Page 29 September 26, 2003 4:50 pm
A
Select the VHS deck.
On the unit
Press VCR/DVD repeatedly so that the VCR indicator
lights up.
On the remote control
Press VCR so that the VCR indicator lights up.
B
Select the L-2 SELECT mode.
Set “L-2 SELECT” to “A/V” or “SAT”. (੬ pg. 64)
● When you select “SAT”, refer to “IMPORTANT” on page 60.
C
Set the tape speed.
Press p.
D
Engage the Automatic Satellite Programme
Recording mode.
On the unit
Press and hold SAT# for
about 2 seconds.
On the remote control
Press and hold REC LINK
for about 2 seconds.
● The “N” and “#” indicators
light up and the unit turns
off automatically.
NOTES:
● Operations on the DVD deck are not possible when the
Automatic Satellite Programme Recording mode is engaged or
timer recording is in progress.
● To disengage the Automatic Satellite Programme Recording
mode, press REC LINK. The “N” indicator goes off.
● If the unit’s power is off, it is not possible to engage the
Automatic Satellite Programme Recording mode.
● In step D, if the “N” indicator does not light but instead blinks
quickly even though your satellite receiver’s power is off,
Automatic Satellite Programme Recording will not work
properly with that satellite receiver*. If this is the case, perform
“Express Timer Programming” (
੬ pg. 26) to timer-record a
satellite programme.
* Some satellite receivers output signals even if the power is off.
Automatic Satellite Programme Recording is not possible with those
satellite receivers.
● The “N” indicator blinks while Automatic Satellite Programme
Recording is in progress.
● For timer programming of the satellite receiver, refer to the
instruction manual of the satellite receiver.
● Automatic Satellite Programme Recording is not possible if
your satellite receiver does not have a timer.
● Pressing the unit’s 1 button while Automatic Satellite
Programme Recording is in progress turns off the unit’s power
and disengages the Automatic Satellite Programme Recording
mode.
● If there are more than one satellite programmes you wish to
record with Automatic Satellite Programme Recording, it is not
possible to set different tape speeds for each programme.
● Depending on the type of satellite receiver, the unit may not
record a slight portion of the beginning of the programme or
may record slightly longer than the actual length of the
programme.
● If you engage the Automatic Satellite Programme Recording
mode when the satellite receiver’s power is on, the unit will
not start Automatic Satellite Programme Recording even
though the “N” and “#” indicators blink. When the satellite
receiver shuts off once and is turned back on again, the unit
starts recording.
● You can also record a programme from your cable system in
the same way if the system has a timer.
● The B.E.S.T. system (
੬ pg. 23) does not work while Automatic
Satellite Programme Recording is in progress.
● Just Clock (
੬ pg. 75) does not work when the Automatic
Satellite Programme Recording mode is engaged.
Before performing the following steps:
● Make sure the satellite receiver is connected to the unit’s
L-2 IN/DECODER connector. (
੬ pg. 60)
● Programme the timer on the satellite receiver.
● Insert a cassette with the safety tab in place.
● Slide the TV/VCR/DVD switch to the right.
XV3EX_07S-VHS.fm Page 29 Friday, September 26, 2003 4:50 PM