Filter
Top Products
Masterpage:Right-No-Heading
11
Filename [XV48EK_06Index.fm]
Page 11 November 18, 2004 10:45 pm
Basic Connections
It’s essential that your unit be properly connected.
A
Situate the unit.
Place the unit on a stable, horizontal surface.
B
Connect the unit to TV.
The connection method you use depends on the type of
TV you have.
RF Connection
8To connect to a TV with NO AV input connectors —
A Disconnect the TV aerial cable from the TV.
B Connect the TV aerial cable to the ANTENNA IN
connector on the rear panel of the unit.
C Connect the provided RF cable between the
ANTENNA OUT connector on the rear panel of the
unit and the TV’s aerial connector.
AV Connection
8To connect to a TV with AV input connectors —
If your TV is equipped with a 21-pin SCART connector,
perform AV connection to improve picture quality during
tape playback.
A Connect the aerial, unit and TV as per “RF
Connection.”
B Connect an optional 21-pin SCART cable between the
L-1 IN/OUT connector on the rear panel of the unit
and the TV’s 21-pin SCART connector.
C
Connect the unit to mains.
Plug the end of the mains power cord into a mains outlet.
TV aerial cable
RF cable (provided)
21-pin SCART cable
(not provided)
Mains power cord
Mains outlet
Back of unit
TV
THESE STEPS MUST BE COMPLETED BEFORE ANY
VIDEO OPERATION CAN BE PERFORMED.
After the connection is completed, perform “Auto Set
Up” on page 12.
XV48EK_01.book Page 11 Thursday, November 18, 2004 10:45 PM