Filter
Top Products
Masterpage:Right-No-Heading
59
Filename [XV48EK_10Subsidiary.fm]
Page 59 November 18, 2004 10:44 pm
Tuner Set
Your unit needs to memorize all necessary stations in channel
positions in order to record TV programmes. Auto Channel Set
automatically assigns all receivable stations in your area to call
them up by using the PR buttons without going through any
vacant channels.
Auto Channel Set
A
Turn on the unit.
Press 1.
B
Select the VHS deck.
On the unit
Press VCR/DVD repeatedly so that the VCR indicator
lights up.
On the remote control
Press VCR so that the VCR indicator lights up.
C
Access the Main Menu screen.
Press SET UP.
D
Perform Auto Channel Set.
● When you have connected
the unit to a TV offering T-V
Link via a fully-wired 21-pin
SCART cable (
੬ pg. 11), the
unit automatically performs
the Preset Download and the
T-V LINK screen will appear.
(
੬ pg. 13)
● The Auto Set screen appears,
and remains on screen while
the unit searches for
receivable stations.
As Auto Channel Set progresses, the “q” mark on the TV screen
moves from left to right. Wait until the TV screen as shown in
step E appears.
E
View the Confirmation screen.
After “SCAN COMPLETED” is
displayed on the TV screen for
about 5 seconds, the
Confirmation screen looking
like the one to the right
appears. The stations your unit
located appear on the
Confirmation screen —
channel positions (PR),
channels (CH) and station names (ID –
੬ pg. 62). The
blueback screen and the programme currently being
broadcast by the blinking station appear alternately for 8
seconds each. To view the next page, use the rt w e
button on the remote control.
● The Guide Program numbers will also be set automatically
during Auto Channel Set.
F
Return to the normal screen.
Press SET UP.
● Using the Confirmation screen, you can skip or add channel
positions, enter station names and perform other operations.
Refer to pages 60 – 61 for the procedures.
●
Depending on reception conditions, the stations may not be
stored in order, and the station names may not be stored correctly.
IMPORTANT
Perform the following steps only if —
— Auto Channel Set has not been set correctly by Auto Set
Up or by Preset Download. (
੬ pg. 12, 13)
— you have moved to a different area or if a new station
starts broadcasting in your area.
● Turn on the TV and select the video channel (or AV
mode).
● Slide the TV/VCR/DVD switch on the remote
control to the right.
Slide to the
right.
Press rt to move the
highlight bar (pointer) to
“AUTO CH SET,” then press
ENTER or e twice.
IMPORTANT
●
In certain reception conditions, station names may not be
stored correctly, and Auto Guide Program Number Set may
not work properly. If the Guide Program numbers are not set
properly when you timer-record a TV programme using the
VIDEO Plus+ system, the unit will record a TV programme
of a different station. When programming the timer using the
VIDEO Plus+ system, be sure to check the desired channel
is selected correctly. (
੬
pg. 24, “VIDEO Plus+
®
Timer
Programming”)
●
Your unit memorizes all detected stations even if reception
of some of them is poor. You can delete those stations with
an unacceptable picture. (
੬
pg. 60, “Deleting a Channel”)
Beginning End
XV48EK_01.book Page 59 Thursday, November 18, 2004 10:45 PM