Filter
Top Products
26
Additional VCR Information
Additional VCR Information
• During manual recording, timer recording, Instant
Timer Recording, playback, or fast forward
modes, the DVD+VCR automatically starts
rewinding the tape at the end of the tape. The
cassette stops at the beginning of the tape and is
ejected.
• After you have finished using the DVD+VCR,
rewind, eject, and remove the cassette. Place the
cassette in its protective sleeve to protect it from
dust. It is not necessary to rewind the cassette
before removing it, but if you do, it is ready to play
or record the next time you use it.
• Be sure the DVD+VCR channel selector is on the
correct channel you wish to record. The channel
that is being recorded can always be checked by
setting the television on the DVD+VCR channel
(CH 3 or 4) and pressing the TV/VCR to turn the
DVD+VCR’s TV indicator off.
• Do not attempt to hook up more than one televi-
sion set to the DVD+VCR for either recording or
playback.
VCR Auto Play System
This DVD+VCR features automatic playback.
When you load a tape with the safety tab removed
the following occurs:
• The Output Source is changed to VCR mode
automatically.
• The power turns on automatically and playback begins.
• At the end of the tape, the DVD+VCR stops, then
rewinds.
• The tape is ejected after rewinding and the turns itself
off automatically.
Note:
Auto power off does not function during regular DVD play
mode. (DVD+VCR power stays on.)
S-VHS Quasi Playback (SQPB)
• This DVD+VCR can play back S-VHS recorded
tapes, however, it cannot make recordings using
S-VHS format tapes.
• SQPB is an abbreviation for S-VHS Quasi
Playback.
Easy Information
If the Extended Data Service (XDS) signals are pro-
vided along with normal TV signal in your area or dur-
ing playback of a tape recorded with Extended Data
Service (XDS) signals, the station ID, program title,
and program details are shown on the TV screen.
When viewing a channel with Extended Data Service
(XDS) signals, press ENTER (OK) and the station ID
will appear on the TV screen. Press ENTER (OK)
again and the program details will appear on the TV
screen.
When viewing a tape recorded with Extended Data
Service (XDS) signals, press ENTER (OK) twice and
the program title and program details will appear on
the TV screen.
Program Details
LENGTH: Indicates the run length of a program.
TIME REMAINING: Indicates the remaining time of a
program.
RATING: Indicates the rating of the current program
(N/A, G, PG, PG-13, R, NC-17, X and Not Rated). The
rating N/A means that the motion picture ratings are not
applicable to this program.
Easy Information Screen
(Program details)
Easy Information Screen
(Station ID)
CH 4
SP WABC STEREO
“Home video”
JAN 1 , MON 2:15 PM
PROGRAM DETAILS
“Home video”
LENGTH 01:00
TIME REMAINING 00:26
RATING N/A