Filter
Top Products
basic features 19
Notes on Recording
When using both the RF and SCART cables, you can switch between TV and
VCR by pressing the
TV/VCR button on the Remote Control.
If the tape reaches its end during recording, the recording stops and “U” and
“,” on the display panel blink. Press S/0on the VCR to eject the tape or press
1 to rewind the tape.
Display Tape Remaining Time
Press the bbutton so that the tape remaining time is shown on the TV
screen with ‘REMAIN’ indication. The on-screen information will disappear
after about 5 seconds.
non-standard tapes Sometimes, a tape will not conform to the standards
accepted by this VCR. In such cases the tape remaining time may not appear
immediately, be incorrect or simply show as ‘– – : – –’.
Change Display Information
By pressing the bbutton repeatedly, you can change the display on the VCR
between the clock time and the preset position. The preset position cannot be
shown during playback.
Resetting the Counter
Press the bbutton so that the counter display appears on the TV screen.
While the display is shown, press the
0000 button. You can reset the counter to
‘0:00:00’ before starting playback or recording.
Record a Programme While Watching Another
Press TV/VCR. The recorder’s VCR indicator and the TV broadcast being
recorded disappear.
Once you have started recording all you need to do is use the controls on your
TV set to tune to a different programme. The programme set using the
PR
button on the Remote Control or the JOG Dial on the VCR is the one which will
be recorded.
T
V
P
R
+
T
V
P
R
–
T
V
–
T
V
+
TV
0000
STOP
FIN
MENU
O
K
TV/VCR
DAILY/QTDN.
VPS/PDC
AUX
?
WEEKLY/HEBDO
PROG
30 SEC
– –:– –
AUDIO
12
3
4
65
7
8
9
0
DATE
START
DEBUT
PR
2
4
1
3
E
N
T
E
R
/
E
N
T
R
E
E
EXPRESS
TV/VCR
AU
2
– –:– –
O
3
0000
7
TE PR
HR-S6955EK-EN/p13-20 3/13/02, 05:06 PM19