Filter
Top Products
12
Before you can operate your remote control, you first
need to install the batteries (included).
Lift and pull the latch on the back of the remote
control to open. Insert two batteries (included)
carefully noting the “+” and “–” markings, placing
the “–” end in the unit first. Snap the cover back into
place.
When you change the batteries, try to complete
the task within three minutes. If you take longer
than three minutes, the remote control codes for
your VCR, DVD, and/or cable box/satellite receiver
may have to be reset. See pages 19 - 22.
Quick Setup Getting Started
Step 2 – The Remote Control
Key Feature Buttons
The four key feature buttons at the center of the remote
can be used for basic operation of the television. The top
and bottom buttons will scan forward and back through the
available channels. To move rapidly through the channels
using JVC’s Hyperscan feature, press and hold CH+ or
CH –. The channels will zip by at a rate of five channels per
second. The right and left buttons will turn the volume up or
down. These buttons are also marked with four arrows and
are used with JVC’s onscreen menu system. To use the
onscreen menus, press the M
ENU button.
MUTING
MENU
OK
BACK
CH +
VOL
–
VOL
+
VCR CHANNEL
VCR/DVD
CH –
Basic Operation
Turn the television on and off by pressing the POWER button at the top right corner
of the remote.
• Make sure the TV/CATV switch is set to TV. Move the switch to CATV only if
you need to operate a cable box.
• Slide the VCR/DVD selector switch to VCR to control a VCR. Slide to
DVD to control a DVD player. Please see pages 19 to 22 for instructions on
programming your remote control to operate a cable box, VCR or DVD player.
POWER
V
VCR
DVD
TV
CATV
V
LCT1899-001B-A ENG 12 8/5/05, 11:41:42 AM