Filter
Top Products
18
Press the MENU button on the remote control
π†
To AUTO TUNER SETUP
è
To operate
è
To choose CABLE (if you are connected to a cable system) or AIR (if you use an
antenna)
Press the OK button
The Auto Tuner will now memorize all of the clear, active channels your television can receive.
This will take one or two minutes.
Quick Setup Auto Tuner Setup
AUTO TUNER SETUP
CABLE
PRESS TO START
SELECT OPERATE EXIT
MENU
TUNER MODE
OK
STOP
48
NOW
PROGRAMMING !
Step 4 – Auto Tuner Setup
The Quick Setup is complete
When the setup is finished, PROGRAMMING OVER ! is displayed. Your quick setup is now
complete. You can now begin watching your television, or you can continue on in this guide
for more information on programming your remote control, or using the JVC onscreen menu
system to customize your television viewing experience.
Cable Box and Satellite Users: After your auto tuner setup is complete, you may, (depending
on the type of hookup), have only 1 channel, usually 3 or 4 in the auto tuner memory. This is
normal.
JVC’s onscreen menu system lets you set your television up to meet your own personal viewing
preferences. The menu screens and their features are discussed in detail in this book. The menu
settings are optional, you can set as many or as few of them as you wish. But to begin watching
your television right away you will need to run the Auto Tuner Setup. This lets your television
learn the channels it is able to receive. To run the Auto Tuner Setup follow the steps below.
LCT1899-001B-A ENG 18 8/5/05, 11:41:44 AM