Filter
Top Products
Getting started
XV-D721BK[J, 1U]EN
LET0486-001B
16
Getting
started
To connect to an audio equipment with a digital input
You can enhance the sound quality by connecting the unit’s DIGITAL output (OPTICAL or COAXIAL) to the digital input
of an amplifier, DAT or MD by using an optional digital cable. The digital audio signal from a disc is directly
transferred. If you connect the unit to a Dolby Digital or DTS decoder or an amplifier with a built-in decoder by using
an optional digital cable, you can enjoy high-quality surround sound.
When you make the digital connection, also make the analog connection, because, depending on the disc type, no
audio may be reproduced from the DIGITAL outputs.
• When you connect the unit's DIGITAL output to a digital audio equipment, before using, make the “DIGITAL AUDIO OUTPUT”
setting in the “PREFERENCE 2” on-screen display correctly according to the connected audio equipment. If the “DIGITAL
AUDIO OUTPUT” is not set correctly, loud noise may be generated from speakers, causing damage to your speakers. See
“DIGITAL AUDIO OUTPUT” on page 42.
• When you connect the unit's DIGITAL output to a Dolby Digital or DTS decoder (or amplifier with a built-in decoder) to enjoy
surround sound, the unit's “COMPRESSION” setting in the “PREFERENCE 2” on-screen display and all settings in the “SPK.
SETTINGS” display are invalid. Make appropriate surround audio settings by the decoder.
• For digital connection, connect the unit’s DIGITAL output (OPTICAL or COAXIAL) to the digital input of an audio
equipment using an optional digital cable.
NOTES
To connect the power cord
When all the audio/video connections have been made, insert the smaller plug of the supplied AC power cord to the
unit’s
AC IN connector, then insert the other end to the wall outlet. Make sure that plugs are inserted firmly. The
STANDBY indicator lights and setup is completed.
Warning
• Disconnect the power cord if you are not going to use the unit for a long time.
• Disconnect the power cord before cleaning the unit.
• Disconnect the power cord before moving the unit.
• Do not connect or disconnect the power cord with wet hands.
• Do not pull the power cord when disconnecting it, as this may damage the cord and cause fire, electric shock, or
other accidents.
Caution
• Do not damage, alter, twist, or pull the power cord, as this may cause fire, electric shock, or other accidents.
• To prevent any accidents or damages caused by an unsuitable AC power cord, only use the supplied power cord. If
the cord is damaged, contact a dealer and get the new power cord.
• Do not put anything heavy, or the unit, on the power cord, as this may cause fire, electric shock, or other accidents.
SCAN MODE
525p 525i
DIGITAL
FRONT CENTER
SUBWOOFER
PCM/STREAM
AUDIO OUT AV COMPU LINK
LEFT LEFT
RIGHT
OPTICAL COAXIAL
VIDEO S-VIDEO
YP
B
P
R
COMPONENT
VIDEO OUT
IN
OPTICAL
DIGITAL
IN
AUDIO
RIGHT
LEFT
ANALOG
RIGHT
REAR
COAXIAL
Audio cable
(supplied)
The unit
Optical digital cable
(not supplied)
White
Red
White
Red
Digital equipment
Coaxial digital cable
(not supplied)
When using the DIGITAL OUT (OPTICAL) jack, remove the
protection cap. Do not lose the removed cap.
When the jack is not used, fix the protection cap into the jack.