Filter
Top Products
Getting started
14
Getting started
You can enjoy using the unit by simply connecting it to your television set with a 21-pin SCART cable. To hear audio
sound with better quality, connect the audio output to your audio equipment.
Set the COMP-Y/C switch correctly according to your TV.
• If the TV only accommodates the composite video signal, set the switch to “COMP.”.
• If the TV accommodates the Y/C signals, set the switch to “Y/C” so that you can enjoy better-quality pictures.
• If the TV accommodates the RGB signals, set the switch to “COMP.”, as well as make the unit feed the RGB signals by
following the procedure shown below.
How to make the unit feed the RGB signals
The unit cannot output the RGB signals from the SCART connector and the S-video (Y/C) signals from the S-VIDEO jack
simultaneously.
In the initial (factory-preset) condition, the S-VIDEO jack is active, while the RGB signals cannot be output.
To make the unit feed the RGB signals, follow the procedure below. Note that the S-VIDEO jack does not feed correct
signals when the unit is set to output the RGB signals.
7 When the unit is turned on
1
Set the COMP.-YC switch to “COMP.”.
2
Press and hold down the
7
(STOP) button on the front panel when no disc is inserted or while the unit is stopped.
"S OUT" appears in the display window after a few seconds.
To connect to a TV with the SCART connector
PCM / STREAM
OPTICALCOAXIAL
AV COMPU LINK
LEFT
RIGHT
AUDIO OUT DIGITAL OUT
COMP. Y/C
AV
VIDEO S-VIDEO
VIDEO OUT AV OUT
TV
SCART cable
(not supplied)
The unit
VIDEO
AUDIO
RIGHT
LEFT
IN
S-VIDEO
IN
AV
3D-PHONIC
DISC TITLE CHAP.
PROGRAM
EACH
REMAIN
DVD VCD
RANDOM
RESUME
REPEAT 1A-B
THEATER
TRACK
(Display window)
0(1*ERRN3DJH)ULGD\0DUFK30