Filter
Top Products
39
ENGLISH
Indications Selectable settings, [reference page]
Sound
Fader/Balance
Adjust fader—speaker output balance between the front and
rear speakers.
•Upmost—front only
•Downmost—rear only
When using a two-speaker system, set the fader to the center
(00).
Adjust balance—speaker output balance between the left and
right speakers.
• Leftmost—left only
• Rightmost—right only
Press ENT to finish the procedure.
Volume Adjust
Adjust and store the volume level of each source except FM.
Once you have made an adjustment, it is memorized, and
the volume level will automatically increase or decrease by
adjusted level when you change the source.
Adjust to match the input level to the FM sound level.
• –12 (min.) to +12 (max.) [Initial: 00]
Subwoofer
Adjust the settings below in the submenu:
• Phase: Subwoofer phase. Select either “Normal” or
“Reverse”, which reproduces a better sound.
• Level*
1
: Subwoofer output level. Level: –06 (dB) to +08
(dB) [Initial: 00 (dB)].
High Pass Filter Through: [Initial]; Select when the subwoofer is not
connected.
On: Select when the subwoofer is connected.
Crossover
Adjust the crossover frequency between the front/rear
speakers and the subwoofer.
80Hz, 120Hz
[Initial]
, 150Hz
*
1
The setting is ineffective when a multi-channel source is played back and Disc Surround is on, or
when Dolby PLII Movie/Music is in effect. Adjust the level on “Speaker Level” [36] for the cases.
Adjusts fader
Adjust balance
Adjust balance
AVX2EN_book.indb 39AVX2EN_book.indb 39 06.1.25 6:20:23 PM06.1.25 6:20:23 PM