Filter
Top Products
13
RS232
Ⅵ Patterns Menu
The best approach to system setup is to use a DVD that
offers the proper test patterns. This way, the system is
aligned for the entire signal path. If a test DVD is not avail-
able, then use the internal test patterns provided in this
unit.
● The test pattern generator in this unit is set to SMPTE stan-
dards. To insure proper output levels for display setup, the
picture controls in this unit cannot be accessed when the
test patterns are being used. Adjust levels, if needed, in
the display device.
INPUT PICTURE
TEST PATTERNS
PATTERNS
DISPLAY
SELECT
ON
CONVERGENCE
AVAILABLE PATTERNS
Gray Step : Check gray scale
Cb Ramp : Check linearity of Cb channel
Cr Ramp : Check linearity of Cr channel
Y Ramp : Check linearity of Y channel
Black : Full Black screen
Green Screen : Check for defective pixels
Red Screen : Check for defective pixels
Blue Screen : Check for defective pixels
Convergence : Check convergence of display
Border : Use for H&V positioning
Multiburst : To check bandwidth
Window : Check displays power supply
PLUGE : Set Brightness and Contrast
Color Bars : Color bars for decoder check
Rev Bars : Color bars for decoder check
RS232 INSTRUCTIONS
Connector : DB-9 Female
Baud rate : 19,200 default, 8 bit,1 stop bit and
No Parity
Pin Configuration : Pin 5=Ground
Pin 3=RX in
Pin 2=TX out
All commands are sent using ASCII text strings.
● A command must start with the string header