Filter
Top Products
Filename [MH50SEK_05Name.fm]
Masterpage:Left0
24 EN
Page 24 Friday, 14 January 2005 16:43
SAT CONTROL SET
The following procedure is required if you receive satellite
channels through a satellite receiver. Approximately 20 seconds
before the VIDEO Plus+ timer programming (A pg. 47) or Manual
Timer programming (A pg. 49) starts, the unit sets its input mode
to AL-2B and automatically switches the satellite receiver’s channels
using the provided Satellite Controller.
Installing Satellite Controller
1 Place the Satellite Controller so that the path between its
transmitter and the satellite receiver’s remote sensor is
unobstructed.
2 Fix securely using the adhesive strip attached on the back of
the Satellite Controller.
3 Be sure to connect the unit’s [L-2 IN/DECODER] connector to
the satellite receiver’s 21-pin SCART connector.
NOTE:
When connecting your satellite receiver, refer to its instruction
manual.
4 Connect the Satellite Controller to the [SAT CONTROL]
connector on the rear panel.
Setting Satellite Receiver’s Brand And Channel
After installation, set the satellite receiver’s brand and channel
correctly; otherwise, the Satellite Controller cannot work correctly.
1 Turn on the satellite receiver’s power.
2 Press SET UP to access the Main Menu screen.
3 Press selection keys to select AINITIAL SET UPB, then press
G.
4 Press selection keys
to select ATUNER
SETB, then press G.
5 Press selection keys
to select ASAT
CONTROL SETB, then
press ENTER.
6 Press selection keys
to select ABRANDB,
then press ENTER.
7 Press selection keys to select the brand code from the list on
page 25, then press ENTER.
● If the unit is in playback or recording mode, you cannot set the
brand code.
8 Press selection keys to select APROGRAMMEB, then press
ENTER.
9 Press selection keys to select one of the channel positions on
the satellite receiver, then press ENTER.
● You can select the channel position between 1 to 999.
10 Press selection keys
to select ATESTB, then
press ENTER. The
unit enters the Test
mode.
Satellite Receiver Control Setting
Satellite receiver
Satellite Controller
(supplied)
(suggested location)
Transmitter
21-pin SCART cable
(supplied)
To [SAT CONTROL]
Your unit
Satellite receiver
Satellite Controller
(supplied)
To [L-2 IN/
DECODER]
Back of unit
ENTER
SET UP
FGDE
CABLE/SAT
DVDTV
Selection Keys
●
Turn on the unit.
● Turn on the TV and select the AV mode.
● Slide the TV/CABLE/SAT/DVD switch to DVD.
13
12
11
DVD VIDEO SET UP
AUTO CH SET
HDD/DVD SET UP
FUNCTION SET UP
INITIAL SET UP
TUNER SET
CLOCK SET
MANUAL CH SET
SAT CONTROL SET GUIDE PROG SET
SELECT WITH @ THEN PRESS [ENTER]
ENTER
SELECT
SET UP
EXIT
PRESS [SET UP] TO EXIT
12
73
INITIAL SET UP > SAT CONTROL SET
BRAND
PROGRAMME
TEST
SELECT WITH @ THEN PRESS [ENTER]
ENTER
SELECT
SET UP
EXIT
PRESS [SET UP] TO EXIT
MH50SEK_00.book Page 24 Friday, January 14, 2005 4:44 PM