Filter
Top Products
Setting up your TV
6
LT-Z32/26S2 (ASIA) / LCT1597-001A / English
ENGLISH
Connecting the aerial and VCR
• Aerial cable is not supplied. Use a good quality 75-ohm
coaxial cable.
• Read the manual that came with the VCR before
connecting.
If not connecting a VCR (follow 1
11
1):
Connect an aerial cable to the aerial socket on this
TV.
If connecting a VCR:
1 Connect the aerial cable to the aerial input
socket on the VCR, and connect the VCR and
TV with another aerial cable
2 Connect the VCR’s VIDEO OUT (video output)
terminal and the TV’s VIDEO terminal with a
video cable
To connect a VCR to the TV with an S-VIDEO cable:
Connect the VCR’s S-VIDEO OUT (S-VIDEO output)
terminal and TV’s S-VIDEO terminal with an S-VIDEO
cable A, instead of connecting with a video cable.
Note that the connection with a video cable will be
ignored in case you connect a VCR to the TV with both
video cable and S-VIDEO cable.
3 Connect the VCR’s VIDEO OUT (audio L/R
output) terminals and the TV’s AUDIO terminals
with an audio cable
• To connect additional external devices, please see
“Connecting the external devices” on page 29.
Connecting the power cord to the AC
outlet
Insert the AC plug on the power cord from the TV into AC
outlet. The power lamp will light and the TV will enter
standby mode.
Caution
• Operate only from the power source specified (AC 110
– 240 V, 50/60 Hz) on the unit.
• Remove the AC plug from the outlet to completely
disconnect the TV from the power supply.
1
1
2
3
VIDEO
L
L
R
IN(VIDEO-1)
VIDEO
AUDIO
S-VIDEO
VIDEO
R
IN(VIDEO-2)
VIDEO
AUDIO
VIDEO
R
AUDIO
S-VIDEO
VIDEO
L
R
OUT
VIDEO
AUDIO
S-VIDEO
IN
(VIDEO-3)
Y
L
R
Cb/Pb
Cr/Pr
COMPOMENT
(VIDEO-4)
AUIDO
L
VIDEO
L
L
R
IN
(
V
ID
E
O
-1
)
V
ID
E
O
A
U
D
IO
S-VIDEO
VIDEO
IN
(
V
ID
E
O
-2)
V
ID
E
O
S-VIDEO
without terminal covers
LT-Z32&26S2_Eng.book Page 6 Thursday, December 18, 2003 10:11 AM