Filter
Top Products
Preparing the Camera for Bluetooth connection
11
When using Blackberry
Configure the setting below to use the GPS function.
Press the menu key and select [Options] - [Advanced
1
Options] - [GPS].
Set [GPS Data Source] to [Device GPS].
2
Set [GPS Service] to [Location ON].
3
Press the menu key and select [Save].
4
When using Touch Pro/Touch Diamond
Register the camcorder after pairing following the steps below.
* If you use HD2, the following operation is not required.
Select [Start] - [Settings].
1
Open [Connection] and select [Bluetooth].
2
Open [Devices] and select a camcorder to connect to.
3
Tick the [Serial port] checkbox and tap [Save].
4
Open the [COM Ports] tab and select [New Outgoing Port].
5
Select a camcorder to connect to and tap [Next].
6
Select the [COM 0] port.
7
Remove the tick in the [Secure Connection] checkbox and
8
tap [Finish].
If [COM 0] is already in use, select the port which has the next
youngest number. If you cannot register, select the next port and try
again.
Tap [OK] on the upper right to close the setting screen.
9