Filter
Top Products
Masterpage:Right-NoTitle0
EN
25
Filename [VS30U_1a-EN.fm]
Page 25 January 31, 2002 3:35 pm
G
Access the DBS Receiver Brand Set screen.
Press OK or
e
.
H
Enter the DBS receiver’s brand.
Press the appropriate number
keys to enter the brand code
from the following list, then
press OK or
e
.
The program currently
received through the DBS
receiver appears for about 10
seconds.
If the DBS receiver’s channel
changes to the channel listed
below for your brand, setting
is complete.
JVC
]
100
ECHOSTAR
]
100
SONY
]
205
RCA
]
205
Press OK or
e
and “DBS RECEIVER CONTROL IS ON”
appears on the screen for about 5 seconds, then it returns
to the normal screen.
If the DBS receiver’s channel does not change as shown
above;
A
Press
rt
to move the highlight bar (arrow) to “NO”,
then press OK or
e
.
B
Repeat step 8.
NOTES:
●
The Controller may not work with all types of DBS receiver.
●
If your DBS receiver does not respond to the code, you cannot
use the Controller to change satellite channels. In this case,
make sure to leave the DBS receiver turned on and tuned to
the proper channel before the scheduled start time of timer
recording.
●
The VCR can only change the satellite channel through the
Controller during timer recording.
●
If your DBS receiver cannot be operated with a Remote
(because it has no remote sensor), you cannot use the
Controller to change its channels. Make sure to leave the DBS
receiver turned on and tuned to the proper channel before the
scheduled start time of timer recording.
●
If the VCR’s memory backup expires because of a power
failure, set the cable box output channel and brand again.
●
For customers in U.S.A.:
If you are unable to set the Controller,
contact JVC toll free at 1-800-537-5722.
BRAND NAME CODE
JVC (DISH Network)
ECHOSTAR (DISH Network)
SONY (DSS)
RCA (DSS)
51
51
41
40
VS30U_1a-EN.fm Page 25 Thursday, January 31, 2002 3:35 PM