Filter
Top Products
Filename [VS30U_1a-EN.fm]
Masterpage:Left
36
EN
Page 36 January 31, 2002 3:35 pm
PLAYBACK/RECORDING ON DV DECK
Basic Playback
(DV deck)
A
Load a cassette.
Make sure the window side is up, the rear label side is
facing you and the arrow on the front of the cassette is
pointed toward the VCR.
●
Do not apply too much pressure when inserting.
●
The VCR’s power comes on automatically.
●
If the erase protection switch is set to “SAVE”, playback begins
automatically. It takes about 15 seconds until the playback
picture appears.
B
Select the DV deck.
Press DV.
●
The DV button lights on the VCR.
C
Find the program start point.
If the tape is advanced past the start point, press
REW (
3
) or turn the ADVANCED JOG dial to the left.
To go forward, press FF (
5
) or turn the ADVANCED
JOG dial to the right.
D
Start playback.
Press PLAY (
4
).
●
The DV playback indicator lights on the VCR.
E
Stop playback.
Press STOP (
8
). Then press EJECT ( ) to remove the
cassette.
●
The DV playback indicator turns off.
NOTE:
When you record a tape on the DV deck with the recording
speed set to “LP”, it is recommended to play back the tape on
this DV deck. Digital video recorder from other manufacturers
may not be able to play back the tape properly.
Turn on the TV and select the AV mode.
1
32
123
456
7
89
0
2
4
1
3
T W
DV S-VHS
Usable cassettes
Only cassettes marked can be used with the DV
deck.
VS30U_1a-EN.fm Page 36 Thursday, January 31, 2002 3:35 PM