Filter
Top Products
24
PBC
PBC stands for Playback Control and refers to special
menus and navigation features that are available on
some Video CDs.
[ON]: Video CDs are played according to the PBC, if
available.
[OFF]:Video CDs are played the same way as Audio
CDs.
AutoPlay
When you load a DVD with AutoPlay turned on, the
Recorder will bypass the Disc menu and trailers and
start playing the movie automatically.
Set [AutoPlay] to [ON] or [OFF].
DivX Registration Code
We provide you the DivX
®
VOD (Video On Demand)
registration code that allows you to rent and purchase
videos using the DivX
®
VOD service. For more
information, visit www.divx.com/vod.
1. Select [About DivX(R)] option then press B.
2. Press ENTER while [Enter] is selected and the
registration code will appear.
3. Use the registration code to purchase or rent the
videos from Divx
®
VOD service at
www.divx.com/vod. Follow the instructions and
download the video onto a disc for playback on
this unit.
Note:
All the downloaded videos from DivX
®
VOD can only
be played back on this unit.
DivX
Remote Control Function
Remote Control A/B/C/D Code
Switching
The remote control is capable of controlling four JVC
video units independently. Each of the units can
respond to one of four codes (A, B, C or D). The
remote control is preset to send C code signals
because your unit is initially set to respond to C
code signals. You can easily modify your unit to
respond to A, B or D code signals.
1. Press STANDBY/ON (1/&) on the unit to turn off
the unit with no video tape inserted.
2. Press the number key “1” for A, “2” for B, “3” for
C or “4” for D while
pressing ENTER (
) down
on the remote control.
3. Press N/`` on the unit for over 5 seconds while
the unit is turned off. The current code appears
on the display window.
4. Press STOP (x) on the remote control, the cur-
rent code on the display window changes to new
code and blinks for approximately 10 seconds.
5. The new code setup on unit and remote is done.
Note:
If the power is interrupted, the remote control code of this
unit will change to “C”. You should reset the remote control
code, if you want to change the code to A, B or D.
STANDBY/ON (1/&)
Number 1-4
STOP (
x)
ENTER (
)
B/``