Filter
Top Products
10
2. Place one hand on top of the plasma display to steady it and with the other hand set the Angle Adjustment Lever
to 20°.
If the Angle Adjustment Lever has already been fastened, perform this task after removing the Angle
Adjustment Lever Lock Screw.
<Instructions for Assembly, cont’d>
Connecting the Power Cord and System Cables
If the Frame Fastening Screws are not
securely fastened the plasma display
may fall, causing potentially fatal injury.
Grip the plasma display as you adjust
the angle, as the plasma display may
tip over and cause injury.
20°
Grip the plasma display firmly while connecting the power cord/system cables, as the display
may tip over and cause injury.
Caution
Caution
Caution
1. Check the Frame Fastening Screws.
Check that the two Frame Fastening Screws on the upper left and right sides of the Wall Mounting Unit are
securely fastened.
Angle Adjustment Lever
Lock Screw
Frame Fastening Screws