Filter
Top Products
13
7. Set the angle of the plasma display.
Hold the upper part of the plasma display with one hand and set the display to the desired angle with the other
hand, using the Angle Adjustment Lever on the Wall Mounting Unit.
8. Fasten the Angle Adjustment Lever.
Once the angle of the plasma display has been set, fasten the Angle Adjustment Lever with the Screw (M5X20)
r.
Check to make sure that the lever is securely fastened and the plasma display does not rattle.
<Instructions for Assembly, cont’d>
Grip the plasma display firmly as you
adjust the angle, as the display may
fall forward and cause injury.
r Screw (M5X20) x 1
Caution
Angle Adjustment Lever