Filter
Top Products
6
Instructions for Assembly
1. Attach the Wall Mounting Unit w to the surface of the wall.
The unit should be attached using the method most suited to the wall structure.
When anchor nuts/bolts are to be inserted into the wall before mounting, either align the actual Wall
Mounting Unit w with the wall to determine the positioning of the holes or calculate the positioning of the
holes using a dimensional drawing of the unit before installing the anchor nuts/bolts.
2. Attach Frame q to the plasma display.
The screws (M5X30) e should be used to attach the Frame q to a plasma display.
A soft mat or similar material should be laid out to prevent damage to the plasma display during attachment to
the unit.
Fasten all bolts and screws securely. Failure to do so may cause the plasma display and Wall Mounting
Unit to fall down, causing potentially fatal accidents.
Improper positioning/installation of the Wall Mounting Unit on the wall may cause the unit to fall down.
Check the structure, material, and strength of the mounting surface thoroughly and carry out installation
in a suitable location. Failure to do so may cause the plasma display and Wall Mounting Unit to fall
down, leading to potentially fatal accidents.
Mounting the Plasma Display
Danger
Position of Wall
Mounting Holes
w Wall Mounting Unit
Wall Surface Side
(Wall Mounting Unit)
eScrews (M5X30) x 10
Align the first Mounting Hole
Plasma Display