Filter
Top Products
22
Operation
The brightness of the indicator light on the control panel can
be adjusted in five levels.
1 Set the [LOCK] switch to AOFFB.
2 Press and hold the [BARS] button, and operate
the [IRIS/AUTO IRIS LEVEL] lever at the same
time.
● Doing so switches to the brightness adjustment mode,
and the brightness of the indicator light changes.
Note:
● Normal operation is disabled when in the brightness
adjustment mode. However, the [OPERATE] button
remains enabled.
3 Determine the brightness level.
● Releasing the [BARS] button upon selecting a
random brightness level restores the normal mode,
and the corresponding brightness level is stored.
The tally circuit comes with two input systems, namely
contact input and open collector input.
This is set to contact input in the factory settings. You can
change this to open collector input via settings of the DIP
switch at the side of the main unit.
Remove the cover at the side of this product, and set the tally
circuit supply system using DIP switch no. 6. (A
24 page)
Adjustment of Indicator's
Brightness
Indicators for which brightness cannot be adjusted:
● [CALL] button
● [PREVIEW] button
● [TALLY] indicator
1
OPERATE BARSLOCK
SCENE FILE
2 3 54
SPEED
VARIABLE
PART
SHUTTER
NORMAL
1/100
1/120 1/250 1/500 1/1000 1/2000
PART
OFF FULL
AOFFB
LEV
IR
AUT
IS
-3dB
-6dB
ALC
LOLUX
LEVEL
LEVEL LEVELGAMMA DETAIL KNEE POINT
AUTO
KNEE
BLACK
COMPRESS STRETCH
WHITE BALANCE MODE
WHITE PAINT
R
R
BLACK PAINT
B
B
PAINT
PAINT
AUTO WHITE
AUTO BLACK
AUTO
OVER OPEN
UNDER
CLOSE
MASTER
BLACK
TALLY
CALL PREVIEW
1
OPERATE BARSLOCK
SCENE FILE
2 3 54
SPEED
VARIABLE
PART
SHUTTER
NORMAL
1/100
1/120 1/250 1/500 1/1000 1/2000
GAIN
18dB
0dB
3dB
6dB 9dB 12dB 15dB
MANUAL
PRESE T
FAW AW A
AW B
PART
PRESET
LEVEL
IRIS MODE
FULL
PRE
SET
FULL
VARIABLE
PART
OFF FULL
Press and
hold
Lever
Operation
Self-illuminating
button that
enables
brightness
adjustment
Input/Output of Rear Ports