Filter
Top Products
Filename [SR-MV30U_04Name.fm]
Masterpage:Left+
22 EN
Page 22 November 12, 2004 2:53 pm
INITIAL SETTINGS
The following procedure is required if you receive your TV
channels through a cable box (descrambler) and/or if you receive
satellite channels through DBS (Direct Broadcast Satellite)
receiver. The Controller allows the unit to automatically switch the
cable box or DBS receiver’s channel during timer recording.
NOTES:
● The Controller is effective for “VCR Plus+
®
Timer Programing”
(੬ pg. 41), “Manual Timer Programing” (੬ pg. 42), or “On-Disc
Timer Programing” (੬ pg. 43).
● When connecting your cable box, refer to its instruction manual.
Installing Controller
1 If both a cable box and a DBS receiver are used, position the
Controller so its signal reaches the receiving windows of both the
cable box and DBS receiver.
2 Fix securely using the adhesive strip attached on the back of the
Controller.
3 Connect the controller to the unit.
If your cable box or DBS receiver does not have audio/video
output connectors
Connect the RF output connector on the cable box or DBS receiver
to the VHF/UHF IN (DVD) connector on the rear of your unit via
antenna splitter.
If your cable box or DBS receiver has audio/video output
connectors
Connect the audio/video output connectors on the cable box or
DBS receiver to the AUDIO/VIDEO INPUT connectors on the rear
of the unit.
● If both a cable box and a DBS receiver are used, it is recommended
that you connect the DBS receiver to your unit’s AUDIO/VIDEO
INPUT connectors and the cable box to your unit’s VHF/UHF IN
(DVD) connector via antenna splitter.
4 Connect the Controller to the CABLE BOX connector on the rear
panel.
Setting Brand And Channel
After installation, set the cable box or DBS receiver’s brand and
channel correctly; otherwise, the Controller cannot work correctly.
1 Turn on the cable box or DBS receiver.
2 Press VCR/DVD repeatedly so that the DVD lamp lights up on
the unit.
3 Press SET UP to access the Main Menu screen.
4 Press we to select “INITIAL SET UP”, then press ENTER.
5 Press we to select “STB SET”, then press ENTER.
6 Press rt to select “CABLE
BOX SET” or “DBS RECEIVER
SET”, then press ENTER.
7 Press rt to select “CABLE
BOX OUTPUT CH” or “DBS
RECEIVER OUTPUT CH”, then
press ENTER.
Cable Box and/or DBS Receiver Control
Setting (DVD Deck Only)
Cable box or DBS receiver
Controller
(suggested locations)
Your unit
CABLE
BOX
Transmitter
To VHF/UHF IN
(DVD)
Controller
To RF output To Audio/video
output
or
Your unit
To AUDIO/
VIDEO INPUT
Cable box or DBS receiver
● Turn on the unit.
● Turn on the TV and select the video channel (or AV mode).
● Slide the TV/CABLE/DBS/DVD switch to DVD.
1
4
7
2
5
8
0
3
6
9
ENTER
SET UP
rtw e
VCR/DVD
SR-MV30U_04Name.fm Page 22 Friday, November 12, 2004 2:53 PM