Filter
Top Products
5
PORTABLE DVD PLAYER USER GUIDE
About This User Guide
Note: Before attempting to connect, operate or adjust this product, please read and save
this User Guide completely.
Thank you for buying the Portable DVD Player. Instructions in this User Guide describe mainly
the use of the remote control. Buttons with the same or similar marking on your Portable DVD Player
itself, have the same functions as those of the remote control. For introduction to the display (Portable
DVD Player), buttons (Remote Control), and various connections, please refer to the Quick Guide.
The section below covers signicant information about the unit’s general behavior. Please
read carefully. If you wish, you can use the same functions on the remote control.
To turn on the DVD player, press
Power on the top panel of the player.
To switch the player to Stand-by mode, press
Power
. To resume to Play mode,
press
Power
again.
When turning on the DVD Player, the unit directly enters DVD mode.
If a disc is already placed on the disc tray, the recorder will start to load the disc right after
power is turned on.
To switch to other modes, do the following:
If there is no disc placed in the recorder, press
Mode to toggle through different modes.
If there is a disc placed in the recorder, press
Stop twice to completely stop DVD playback.
Press
Mode to toggle through different modes.
When pressing
Stop once during DVD playback, the player turns to a pre-stop status and
memorizes the position where the playback is stopped. To start play from where the playback
has been stopped, press
Play.
Press
Stop twice to completely stop playback.
If an “INVALID KEY” appears on the left top corner of the screen, it indicates that the action
is prohibited or not available.
r
r
r
r
r
1.
2.
r
r
r