Filter
Top Products
Receiver operation
11
Note
With the setting “2- or 3-digit programme selection” there is a switch to the desired
programme after approximately 3 seconds. Digits can be entered during this time
period.
With the setting “free programme selection“, the receiver switches to the corre-
sponding programme slot immediately after each input. (see example above).
In the initial setup menu, a continuous on-screen display of the programme slot can
be selected (see section: “Initial settings, On Screen Displays “).
Adjusting volume, balance and tone
•
If you press one of the
keys the following menu appears for adjustment
of the volume, balance, tone (treble and bass), stereo-width and pseudo-stereo:
With the
keys or the key you can select the respective menu entry
and then makes changes with the
keys.
The settings are not operative at the VCR Scart socket in order not to disturb video
recordings.
The on-screen display is removed again after approximately 3 seconds.
Note
In the menu entry “Stereo Width" the stereo base width can be adjusted independ-
ently.
“Pseudo-Stereo" can be used to simulate a “stereo-like” effect with mono pro-
grammes, and should thus only be activated with mono reception.
The “pseudo-stereo” effect can be simulated if a stereo programme is switched to
mono.
Muting the sound
•
Press the
key.
The sound is muted, allowing you to make a phone call undisturbed, for example.
•
Press the
key again to turn the sound back on.
Note
Mute is not operative at the VCR Scart socket.