Filter
Top Products
Initial settings
19
Programmieren von Radio-Programmen
Programme providers are continually bringing out new radio programmes for
broadcast via the satellites. The “Radio“ menu allows you to store these pro-
grammes.
The settings for radio programmes in “Radio“ mode are carried out in the same
way as for the “TV“ mode.
Tuning in radio programmes
•
Switch from “TV mode“ into “Radio mode“ using the
key.
•
First select the programme slot that is to be programmed afresh.
•
Call up the radio menu by pressing the
+ keys in succession.
•
Select the desired menu line using the
keys.
•
For direct numeric input use the keys
...
or
•
Alter the values step-by-step with the
keys.
•
Press the
key twice in order to save your settings.
•
Exit from the menu with the
key.
The “radio” menu
The following settings can be made in the radio menu:
Radio programme: R 02
Sat frequency: 11214 MHz
Polarisation: Hor. Low
Orbit position: 1
Deviation: 16 MHz
Oscillator: LO 1
Mode: STEREO
Frequency: 7.38/7.56 MHz
De-emphasis: DNR/75µs
VOL 0-9 A/B STOR STBY
The bottom line shows the keys you can use to make the settings.
Radio programmes are transmitted on sound subcarriers only. The setting to be
made is therefore either “Stereo“ or “Mono narrow“. Here the audio de-emphasis is
selected automatically as “DNR“ and 75 µs.
Note
You can terminate any setup procedure immediately (also without storing) by re-
turning to normal operation via the
key.Grundeinstellungen
In the initial setup menu, matching of the satellite receiver to the satellite receiving
system is carried out.
Important
The receiver has already been factory pre-programmed for standard satellite re-
ceiving systems.
Alterations to the initial setting are therefore necessary only if your receiving sys-
tem deviates from this type of installation or if you happen to want different set-
tings.
The settings in the initial setup menu are generally carried out by the specialist
dealer on installation of the satellite receiving system.
To prevent any unintentional alterations in the initial settings, the initial setup menu