Filter
Top Products
Initial settings
34
DiSEqC MENU
The settings for the DiSEqC signal are displayed on the screen:
The settings have the following meaning:
22 KHz Settings:
High/Low Switchover from low band to high band on LNB.
Pos A/B Switchover between two satellite positions.
OFF No 22kHz-controlled LNB is present in the system .
The default setting is “High/Low“.
Tone burst Settings:
OFF The tone burst signal is switched off.
Pos A/B Switchover between two satellite positions.
Opt. A/B Optional selection
High/Low Switchover from low band to high band on LNB.
The default setting is “OFF“.
DiSEqC Settings:
ON The DiSEqC signal is switched on.
OFF The DiSEqC signal is switched off.
The default setting is “ON“.
DiSEqC repeat
Settings:
OFF The DiSEqC repeat is switched off.
1 The DiSEqC signal is repeated once.
2 The DiSEqC signal is repeated twice.
The default setting is “OFF“.
UFO mini Settings:
OFF No subscriber-controlled preprocessing system is present.
ON A subscriber-controlled preprocessing system is present.
The default setting is “OFF“.
Remote frequency Intermediate frequency of subscriber-controlled preprocessing system.
Settings in the DiSEqC menu should be carried out only by trained specialists.
Incorrect settings can result in loss of the satellite signals (reception no longer
possible).