Filter
Top Products
Installation Menu
22
In this menu you can run the scan.
1) AutoScan
All channels in the 177 to 858 MHz frequency range are
scanned for programmes.
2) Net Scan
The complete network is scanned for network information
(The result only appears if the information is broadcast by the
provider).
3) TP Scan
This can be used to locate specific channels.
4) PID
Enter audio and video PID for detailed searching for specific
channels.
5) Scan Mode
Select the scan: All or FTA (free-to-air programmes only) - If
you scan for all programmes, all programmes will be stored,
including the encrypted ones; otherwise only the FTA
programmes are stored.
Channel search:
Note: In addition to displaying the reception strength and quality, the
receiver also features an audio-signal help function to aid in
adjusting the antenna. It can be activated in this menu using the
Mute button.
Press the red button to start scanning the complete frequency range.
The receiver asks you if you want to delete the existing channels.
If you answer «Yes», all the assigned channels are deleted and
the new setup is placed on the main list (in the order of the factory
pre-programming).
If you answer by pressing «EXIT», the scan is not started.
Note: If you are in a catchment area covered by two DVB-T networks,
it may be that the AutoScan causes some programmes to be
duplicated in your channel list. You can simply leave them,
or you can choose to use the channel offering the best picture
(reception) and delete the other one.
Press the green button to scan for a specific channel. The channels
found are placed at the end of the channel list.
PID (Programme Identification) input:
Press the yellow button. Key in the video and audio PID, and press
the yellow button again. The channel is placed at the end of the main
list, tagged «TV CH».