Filter
Top Products
6
The UFS 733 receiver is suitable for the reception of digital satellite TV and radio channels. The decoding
system for Conax is already integrated. In addition one Common Interface for a CA module is provided for
decoding additional Pay-TV channels.
The HDMI interface offers the optimum capability for connecting the receiver to a flat-screen TV set.
The receiver has comprehensive features such as 16-character alphanumeric display for program
names, electrical and optical audio outputs for Dolby Digital (AC3) and Videotext with memory capacity
for 800 pages.
The receiver is available in silver or black housings.
- UFS 733si (silver) or UFS 733sw (black)
- Infra-red remote control
- Scart cable
- 2 batteries AAA 1.5 V
- Power supply cable
- Operating manual
- Safety instructions
PRODUCT PACKAGE
RECEIVER FEATURES
RECEIVER FEATURES AND PRODUCT PACKAGE
SWITCHING OFF THE RECEIVER AND UPDATING THE EPG
By pressing the
button on the remote control you can switch the receiver out of TV mode to the
standby mode, and back again.
The receiver has the facility to update the EPG overnight, i.e. at 03:00 the receiver automatically starts to
update the EPG data. This procedure may take a few minutes, and is not shown in the receiver display.
If the receiver is programmed to make a recording at this time, the updating is postponed until 03:00 the
following night.
The update time cannot be changed.
This updates the EPG data for the fi rst 25 channels of the overall channel list. However, this update is only
performed if the receiver is in the standby mode. If the receiver is completely switched off (at the mains) or
if it is in operation, the update will be delayed. After updating the data, the receiver automatically switches
back to the standby mode. If during the update you press the
button, the update is aborted and the
receiver switches itself on.