Filter
Top Products
6
The UFS 790si and UFS 790sw receivers enable digital satellite and digital terrestrial TV and radio
channels to be received.
The decoding system for Conax is already integrated. In addition one Common Interface for a CA module
is provided for decoding additional satellite Pay-TV channels.
The HDMI interface offers the optimum capability for connecting the receiver to a suitable fl at-screen
TV set.
The receivers have comprehensive features such as 16-character alphanumeric display for program
names, electrical and optical audio outputs for Dolby Digital (AC 3) and Videotext with memory capacity
for 800 pages.
These receivers are available in silver or black housings.
- UFS 790si (silver) or UFS 790sw (black)
- Infra-red remote control
- Scart cable
- 2 batteries AAA 1.5 V
- Power supply cable
- Operating manual
PRODUCT PACKAGE
RECEIVER FEATURES
RECEIVER FEATURES AND PRODUCT PACKAGE
SWITCHING OFF THE RECEIVER AND UPDATING THE EPG
By pressing the
button on the remote control you can switch the receiver out of TV mode to the standby
mode, and back again.
The receiver has the facility to update the EPG overnight, i.e. at 03:00 the receiver automatically starts to
update the EPG data. This procedure may take a few minutes, and is not shown in the receiver display. If the
receiver is programmed to make a recording at this time, the updating is postponed until 03:00 the following
night.
This update time cannot be changed.
This updates the EPG data for the fi rst 25 channels of the overall channel list. However, this update is only
performed if the receiver is in standby mode. If the receiver is completely switched off (at the mains) or if it
is in operation, the update will be delayed. After updating the data, the receiver automatically switches back
to the standby mode. If during the update you press the
button, the update is aborted and the receiver
switches itself on.