Filter
Top Products
14
Remote Control
Remote control unit
In case of difficulty
Cause
• The batteries are nearing exhaustion.
• Subwoofer is OFF.
• No setup codes registered at for the respec-
tive input(s).
• The remote control is set to a different
operation mode.
• Batteries are exhausted.
• The remote control unit is too far away from
the main system, controlling angle is too
large, or there is an obstacle between the
receiver and the remote.
• The audio cords and system control cords are
not connected properly.
• No software is loaded in the source
component.
• An attempt is made to play a tape which is
being recorded in the cassette deck.
• The remote control has not been set to the
operation mode for the component you wish
to control.
• The microprocessor of the remote control
malfunctions.
Remedy
• Replace with new batteries to preserve the
currently registered setup information. $
• Turn the subwoofer ON. %
• Register a setup code or Non-IR code at the
respective input(s). RC3
• Press the MUSIC, MOVIE, or TV keys to
select the appropriate operation mode.
• Replace with new batteries. $
• Operate the remote control unit within the
controllable range.
• Connect properly referring to “Setting up the
system”. 8
• Place software in the source component you
want to play.
• Wait until recording has completed.
• Press the MUSIC, MOVIE, or TV keys to
activate the operation mode for the
component you want to control before
operation. RC5
• Reset the microprocessor. §
Symptom
The battery indicator flashes during opera-
tion.
Subwoofer volume cannot be adjusted.
Certain inputs cannot be selected using the
remote control.
Remote control operation is not possible.