Filter
Top Products
D16XD EasyStart
6. Press the [MIXER] key, and then press the “ANALOG COMP” button in the display
Ä press the “OFF” button for
channel 1 in the display to turn it “ON”.
7. Press “Recall” in the display
Ä press the “” popup button to choose a preset. For guitar, select “P029 E.G.Rhythm”
press “OK” then “Yes”. For a microphone, select “P030:Male Vocal1” or “P32:Female Vocal1”.
! If the guitar you are using has active pickups, you may need to press the PAD key (-26dB), and turn the TRIM knob up
to set the appropriate input level.
! You can also make changes to the compressor preset, and then name and save it to one of 50 user programs by
pressing the “Store” button in the display.
(See the D16XD Owner’s Manual pages 46-47 and page 115 for more on the analog compressors, and pages 42-45 /page
100 for more on inputting audio)
Assign effects and EQ to the input:
1. Press the [EFFECT] key then press the “InsertEFF” tab. In the upper left corner of the display make these settings “IN”
“CH: 01” “InsEFF1”. Press the “” popup button to choose an insert effect. If you are recording a guitar, select
“Multi” then select “P120: BOUTIQUE CLEAN” and press “OK”. For a microphone, select “SFX&etc” from the Mono
effect catagories then select “P109: Studio Mic&Pre” and press “OK”
2. Press the “MstrEFF1” tab
Ä Press the “” popup button to choose a master effect. Select “Reverb&Delay” Äselect
“P002: Smooth Hall” then press “OK”
3. Press the [CH SELECT] key for channel 1
Ä Press the [CH VIEW] key. Press the SEND INTERNAL [1] key located in
the top right hand corner of the adjustable display. Rotate the SEND knob right to add some reverb.
4. Press the [MIXER] key
Ä press “EQ/ATT/PHASE”. Press the “EQ Library” tab. For guitar, select “P15: E.G. Clean” Ä
press “Recall” then “Yes”. For microphone, select “P25: Male Vocal 1” or “P27: Female Vocal 1” Ä press “Recall”
then “Yes”.
Record with the Metronome / Rhythm Patterns:
1. Press the [TEMPO] key, and then press the “SetUp” tab
Ä in the lower left of the display, press the “” popup button
and select “004: 8bt Rock1”, and then press “OK”.
2. Press the “Rhythm On” button in the display
Ä press “Prev<))”, and then set the desired tempo. When finished, press
to turn “Prev<))” OFF.
3. Press the [METER] key (lower left corner of the display)
Ä press the [ ] button (it will blink red), and then press the []
button to start recording Ä when finished recording, press [] and then press [<] [MARK JUMP] to return to the
beginning of the song.
4. Press the red [REC/PLAY] key for Channel 1 so that it changes to green, and then press the [] button to playback the
track.
If you want to overdub another part, repeat the steps, starting with the “Assign an input” section, only this time use
Channel 2.
(See the D16XD Owner’s Manual pages 61-64 for more on the Metronome, Rhythm patterns and Tempo Maps)
6