Filter
Top Products
8 TBUS-6xl - Installing the TBUS-6xl
5 Installing the TBUS-6xl
To install the TBUS-6xl perform the following steps:
1. Assemble the inner frame (see
Section 5.1
2. Install the inner frame (see
).
Section 5.2
3. Cut an opening in the table (see
).
Section 5.3
4. Insert the unit through the opening and secure to the table (see
).
Section 5.4
5. Connect the cables (see
).
Section 5.5
6. Insert pass-through cables (see
).
Section 5.6
7. Adjust the height of the inner frame (see
)
Section 5.7
5.1 Assembling the Inner Frame
).
The modules mounted on the inner frame can include single inserts and/or dual
inserts as well as a power socket (in some models). This section describes how to
assemble these modules.
i
Each module kit comes with detailed assembly instructions.
5.1.1 Mounting the Inserts
You can rearrange or remove any of the plates mounted on the inner frame and
replace them with Kramer passive wall plates or connector modules for interfacing
A/V type signals.
To mount a Kramer insert or connector module:
1. Unscrew the two screws that fasten the blank plate to the inner frame and
remove the blank plate.
2. Place the required Kramer insert over the opening, insert the two screws to
fix the Kramer insert in place, and tighten them.