Filter
Top Products
12 TBUS-6xl - Installing the TBUS-6xl
5.4 Inserting the TBUS-6xl through the Cut Out Opening
To install TBUS-6xl in the opening:
1. Remove the protective rubber guard from around the outer rim of the
TBUS-6xl housing. Beware of the sharp edge!
2. Carefully insert the unit into the prepared opening (see
Figure 5).
3. Take the support brackets under the table and place them into the support
bracket grooves on both sides of the unit (see
Figure 1).
4. Verify proper alignment of the unit before tightening the mounting screws.
5. Tighten both mounting butterfly screws upward until they reach the table
surface (from underneath). Tighten firmly (see
Figure 5).
6. Tighten the locking butterfly screws downward until tight against the
mounting bracket.
Figure 5: Inserting TBUS-6xl into the Prepared Opening