Filter
Top Products
Connection to External equipment
12
VCR Setup
- In Video mode, TV automatically reverts to TV mode if the CH FF / GG
button or number buttons are pressed.
Connection 1
Set VCR switch to 3 or 4 and then tune TV to the same channel num-
ber.
Connection 2
1. Connect the audio/video output jacks on VCR to the corresponding
input jacks on the TV. When connecting the TV to a VCR, match the
jack colors (Video = yellow, Audio Left = white, and Audio Right =
red).
2. Insert a video tape into the VCR and press PLAY on the VCR. (Refer
to the VCR owner’s manual.)
3. Use the INPUT SELECT button on the remote control to select AV1
or AV2. (If connected to S-VIDEO on side panel, select the S-Video
external input source.)
Cable TV Setup
- After subscribing to a local cable TV service and installing a converter,
you can watch cable TV programming.
- For further cable TV information, contact a local cable service provider.
Connection 1
1. Select 3 or 4 with channel switch on cable box.
2. Tune the TV channel to the same selected output channel of cable box.
3. Select channels at the cable box or with the cable box remote control.
Connection 2
1. Connect the audio/video output jacks on Cable Box to the corre-
sponding input jacks on the TV. When connecting the TV to Cable
Box, match the jack colors
(Video = yellow, Audio Left = white, and Audio Right = red).
2. Use the INPUT SELECT button on the remote control to select AV1
or AV2.
3. Select channels with the cable box remote control.
S-VIDEO
AV1
VIDEO
AUDIO
ANT. IN
AC INPUT
L
R
AV2
VIDEO
AUDIO
L
R
OUT
IN
CH3 CH4
S-VIDEO
ANT IN
ANT OUT
(R) (L)
AUDIO VIDEO
Typical
Antennas
VCR
Direct
Connection
S-VIDEOS-VIDEO
AAV1V1
VIDEOVIDEO
AUDIOAUDIO
ANTANT. IN. IN
AC INPUTAC INPUT
LL
RR
AAV2V2
VIDEOVIDEO
AUDIOAUDIO
LL
RR
TV
VCR
(R) AUDIO (L) VIDEO
RF Cable
Cable Box