Filter
Top Products
2-1
Installation
54-0195 Rev. A
2 Installation
TracVision L2 is designed for simple installation and setup. Just
follow these easy steps:
Step Refer to Section...
1. Choose the antenna location 2.1
2. Mount the antenna unit 2.2
3. Connect the system components 2.3
4. Activate the IRD 2.4
5. Check out the system 2.5
Tools and Materials Required
• Electric drill
•
3
⁄16"-drill bit and
3
⁄4" hole saw and auger bit
• #2 Phillips and #0 flat tip screwdrivers
• RG-6 or RG-11 (75 ohms) RF cable (if installing
two RF cables - refer to Section 2.3.2 for details)
• Silicone sealant or RTV
•
7
⁄16"-open end wrench
• Adhesive suitable for specific roof construction
and materials (e.g., Liquid Nails)
• Rivet gun and
3
⁄
16"-rivets (or other fastener suitable
for specific roof construction)
• (Recommended) PC with terminal emulation
software such as PROCOMM or Windows
Terminal or Hyperterminal and a DB9 (male-to-
female) PC data cable
Plan the entire installation before
proceeding! Take into account
component placement, cable
running distances between units,
and accessibility to the equipment
after installation.
While some DIRECTV IRDs
offer on-screen messages, it is
recommended that a PC be
available for all installations of
DIRECTV, EchoStar, and
ExpressVu.
Table 2-1
Installation Process