Lenoxx Electronics DVD-1002 DVD Player User Manual


 
IB-DVD1002 (AT)-WM-E-032706
PRECAUTIONS
Safety
As the laser beam used in the DVD player
may be harmful to the eyes, do not attempt
to disassemble the cabinet. Refer servicing
to qualified personnel only (it is perfectly
safe if you dont unscrew and open the
cabinet).
Should any solid object or liquid fall into
the player, unplug the player, and have it
checked by qualified personnel before
operating it any further.
Placement of Your DVD Player
Do not leave the player in a location near a
heat source, or in a place subject to direct
sunlight, excessive dust or mechanical
shock.
Do not place the player on an inclined or
unstable place.
Do not place anything within 1 inch of the
sides or back of the cabinet. The ventilation
holes must not be covered for the player
to operate properly and prolong the life of
its components.
Dont place this DVD player on lacquered
finished furniture without a wood or glass
protector.
If the player or discs will be left in a car
parked in the sun, put the player in the trunk
or where the player will not be subjected
to the direct rays and heat of the sun.
Cleaning the Cabinet
Clean the cabinet, panel and controls with
a soft cloth slightly moistened with a very
mild detergent solution or a plain damp
cloth. Do not use any type of abrasive pad,
scouring powder, or solvent, such as
alcohol or benzine.
Operation
If the player is brought directly from a cold
to a warm location, or is placed in a very
damp room, moisture may condense on the
lens inside. Should this occur, the player
may not operate properly. In this case,
remove the disc and wait about an hour for
the moisture to evaporate. If the player has
not been used for a long time, turn the set
to ON to warm it up for a few minutes before
inserting a disc.
This DVD player is designed to be played
on a stable non vibrating position. If you bump
the set during DVD play, the picture or music
may stop or skip for several seconds. This
is normal for this type of player.
10
Cleaning Discs
Before playing, make sure the disc is
clean. If not, clean the DISC with a cleaning
cloth. Wipe the DISC in a straight motion
from the center out.
Do not use solvents such as benzine,
thinner, commercially available cleaners or
anti-static spray intended for vinyl LPs.
Do not touch the playback side of the disc.
Every fingerprint can cause playback
problems. Do not scratch the disk.
Do not store the Discs in a place subject
to direct sunlight or near heat sources.
Handling Discs
IB-DVD1002(AT)-WM-E-032706.pmd 7/5/2006, 10:24 AM11