Filter
Top Products
95
Operation
Use the
DD
/
EE
/
FF
/
GG
button to change main and sub picture sizes in Twin Picture mode.
If screen is adjusted to the
maximal size, the large
screen is filled with entire
screen vertically as shown.
i.e)
Use the SWAP button to switch the main and sub pictures.
• Component 1, Component 2, RGB-PC (or RGB-DTV), HDMI/DVI input sources for the main picture can’t be used to swap
the main and sub pictures.
- Use POP to search the programs of all the memorized channels one-by-one on the 3 PIP screen display, (while
the main picture source remains the current channel). The pictures of all the programmed channels are
searched with the 3 POP screen.
- Run EZ Scan channel search before using POP mode.
- When Sub pictures are changed from the TV/DTV to CATV/CADTV in POP mode, it may make a noise from
the Tuner switch.
1. Press the PIP button to activate the POP mode while in PIP mode.
• Channel selection: Use
FF
button to enlarge the selected channel being
searched on the PIP screen to shift it for viewing on the Main screen.
• PIP selection: Use
DD
/
EE
button to select one of 3 PIP screen pictures in POP
mode.
• When watching TV on Main picture, TV or DTV on Sub pictures are in channel
scanning. However, when watching DTV on Main picture, only TV on Sub pic-
ture is in channel scanning.
2. Press the EXIT button to cancel POP mode.
Main Picture
PIP
Twin
Picture
Sub Picture
SWAP
SWAP
FF
TV 2-0
TV 4-0
TV 6-0
EE
DD
Adjusting Main and Sub Picture Sizes for Twin Picture
Swapping the PIP/Twin Picture
POP (Picture-out-of-Picture: Channel Scan)