LG Electronics 32/42/47LD7*** TV Antenna User Manual


 
2
EXTERNAL EQUIPMENT SETUP
EXTERNAL EQUIPMENT SETUP
CONNECTING WITH A COMPONENT CABLE
To avoid damaging any equipment, never plug in any power cord until you have finished connecting
all equipment.
This section on EXTERNAL EQUIPMENT SETUP mainly uses diagrams for the 32/37/42/47/55LE7
***
models.
Image shown may differ from your TV.
This TV can receive Digital RF/Cable signals without an external digital set-top box. However, if you do
receive Digital signals from a digital set-top box or other digital external device, refer to the diagram as
shown below.
HDMI Audio Supported format : Dolby Digital, PCM.
DTS Audio format is not supported.
Component Input ports
To achieve better picture quality, connect a DVD player to the component input ports as shown below.
Signal Component HDMI
480i/576i O X
480p/576p
O O
720p/1080i O O
1080p
O
(50 Hz / 60 Hz only)
O
(24 Hz / 30 Hz /
50 Hz / 60 Hz)
Component ports on the TV Y PB PR
Video output ports
on DVD player
YP
B PR
Y B-Y R-Y
YCbCr
YPbPr
1
Connect the video outputs
(
Y, P B, PR
)
of the
external equipment (digital set-top box, DVD,
etc.) to the COMPONENT IN VIDEO jacks on
the TV.
2
Connect the audio output of the external equip-
ment (digital set-top box, DVD, etc.) to the
COMPONENT IN AUDIO jacks on the TV.
3
Turn on the external equipment.
(
Refer to the external equipment's manual for
operating instructions.)
4
Select the Component1 input source using the
INPUT button on the remote control.
If connected to COMPONENT IN 2, select
Component2 input source.
1
2
1
2
or
Downloaded From TV-Manual.com Manuals