Filter
Top Products
PAGE 21
206-4118
Antenna
(or CATV)
Antenna
(or CATV)
TV Link
Loader-Demo
TLL1100A
Ready
TLL1100A
ENTER
RECEIVE SEND
MENU
MODE
CLONE SELECTION MENU
Selected Bank: CBank X Saved
(1) LEARN FROM TV
(2) TEACH TO TV
(3) SET CLONE CLOCK FROM TV
(4) SET TV CLOCK FROM CLONE
(5) DISPLAY TV SETUP
(6) DISPLAY CLONE SETUP
CLONE CLOCK = 00:00
TV CLOCK = 00:00
THE CLONE IS VERSION V2.2.2
-To change menu items, Press
channel keys or digits.
-To execute item, Press ENTER.
CLONE SELECTION MENU
Selected Bank: CBank X Saved
(1) LEARN FROM TV
(2) TEACH TO TV
(3) SET CLONE CLOCK FROM TV
(4) SET TV CLOCK FROM CLONE
(5) DISPLAY TV SETUP
(6) DISPLAY CLONE SETUP
CLONE CLOCK = 00:00
TV CLOCK = 00:00
THE CLONE IS VERSION V2.2.2
-To change menu items, Press
channel keys or digits.
-To execute item, Press ENTER.
M.P.I. Learning Setup
M.P.I. Teaching Setup
TV Link
Loader-Demo
TLL1100A
Ready
TLL1100A
ENTER
RECEIVE SEND
MENU
MODE
Connections for the TLL-1100A Clone Programmer to Learn the TV Master TV Setup
Notes: It is assumed that the TV is connected to a signal
source, the TV source selected is Antenna (RF) In, the signal is
from an Analog channel, not a digital channel, all equipment is
connected to power and turned on and the TLL Cloner main
menu is displayed on the TV screen, see above.
TLL-1100A Cloning Connections/Learning Setup
Warning: Do not use the TLL-1100A while any PPV card is installed in TV or
clone programmer device will be damaged.
On Master TV
Set up all Master TV features on
the menus and do a Channel
Search. Add Channel and Aux
labels etc. See previous page.
Insert MPI cable into TV MPI port.
On TLL-1100A
1. Turn On the TLL-1100A.
2. Use the Mode button to select
Clone Mode.
3. Use the Left/Right arrow to
select the CBank (1 - 8) to
store the master setup in.
4. Plug the other end of the MPI
cable into the MPI port on the
bottom of the TLL.
5. With the Installer remote con-
trol, select item 1 on TLL menu.
6. Press Enter, to transfer the
Master setup into CBankX on
the TLL. The TLL will copy the
master setup.
7. When learning is done, discon-
nect MPI cable from Master TV.
8. Reconnect TV power cord. Power
the TV On and the master setup
should be resident on the TV.
On Target TV
1. Connect MPI cable from the TLL
to the MPI port on the Target
TV. Assure that the correct
CBank(X) is selected on TLL..
2. With the Installer remote con-
trol select item 2, to Teach the
target TV the master TV setup.
3. Press Enter to begin teaching.
4. When Teaching is done, discon-
nect MPI cable and power the
TV Off. Unplug TV power cord.
5. Reconnect TV power cord.
Power the TV On and the mas-
ter setup should be resident on
the TV.
GG
If an analog channel is not available, tune TV to an Aux source lik AV-1 for cloning purposes.