Filter
Top Products
A-20
PREPARATION
PREPARATION
BACK COVER FOR
WIRE ARRANGEMENT
■ Image shown may differ from your TV.
1
2
NOTE
►Do not use the Cable Management Clip to lift
the TV.
- If the TV is dropped, you may be injured or the
TV may be damaged.
Connect the cables as necessary.
To connect additional equipment, see the
External Equipment Setup section.
Open the Cable Management Clip as
shown.
Cable Management Clip
Fit the Cable Management Clip as shown.
3
STAND INSTALLATION
Fix the 4 bolts securely using the holes in
the back of the TV.
■ Image shown may differ from your TV.
When assembling the desk type stand, check
whether the bolt is fully tightened. (If not tightened
fully, the product can tilt forward after the product
installation.) If you tighten the bolt with excessive
force, the bolt can deviate from abrasion of the
tightening part of the bolt.
4
Carefully place the TV screen side down
on a cushioned surface to protect the
screen from damage.
Assemble the TV as shown.
1
3
Assemble the parts of the Stand Body with
the Stand Base of the TV.
2
Stand Body
Stand Base
Assemble the parts of the Stand Rear
Cover with the TV. (Only 32/42/47LD7
***
,
32/37/42LD8
***
)
5
Stand Rear
Cover
Downloaded From TV-Manual.com Manuals