Filter
Top Products
A-39
PREPARATION
STAND INSTALLATION
■ Image shown may differ from your TV.
When assembling the desk type stand, check
whether the bolt is fully tightened. (If not tightened
fully, the product can tilt forward after the product
installation.) If you tighten the bolt with excessive
force, the bolt can deviate from abrasion of the
tightening part of the bolt.
Assemble the parts of the Stand Body with
the Stand Base of the TV.
At this time, tighten the screws that hold the
Stand Body on.
2
Stand Body
Carefully place the TV screen side down
on a cushioned surface to protect the
screen from damage.
1
M4 X 20
Stand Base
Assemble the TV as shown.
3
Fix the 4 bolts securely using the holes in
the back of the TV.
4
M4 X 12
BACK COVER FOR
WIRE ARRANGEMENT
■ Image shown may differ from your TV.
After Connecting the cables as necessary,
install Cable Holder as shown and bundle
the cables. To connect additional equip-
ment, see the External Equipment Setup
section.
1
FOR DESK-TYPE STAND
FOR WALL MOUNT
Install the Cable Management Clip as
shown.
1
Cable Management Clip
Connect the cables as necessary. To con-
nect additional equipment, see the External
Equipment Setup section.
2
Cable Holder
NOTE
►Do not use the Cable Management Clip
to lift the TV.
- If the TV is dropped, you may be injured or
the TV may be damaged.
Downloaded From TV-Manual.com Manuals