Filter
Top Products
INTRODUCTION
13
■
Open the battery compartment cover on the back
side and install the batteries matching correct
polarity
(
+with +,-with -
)
.
■
Install two 1.5V AA batteries. Don’t mix old or
used batteries with new ones.
■
Close cover.
■
Use a remote control up to 7 meters distance
and 30 degree (left/right) within the receiving
unit scope.
■
Dispose of used batteries in a recycle bin to
preserve environment.
TVTV
INPUT
INPUT MODE
DVD
RATIO
PIP
Ez PIC SWAP INFO
Ez SOUND
PIP CH + PIP CH -
PIP INPUT
VCR
POWER
Installing Batteries Remote control effective range
TV, DVD, VCR,
PIP
PIP CH-/PIP CH+
PIP INPUT
SWAP
Ez PIC
Ez SOUND
INFO
DAY+/DAY-
THUMBSTICK
(Up/Down/Left
Right/ENTER)
VOLUME +/-
FLASHBK
MUTE
CHANNEL +/-
PAGE UP/DOWN
Select the remote operating mode: TV, DVD, or VCR.
Switches the sub picture PIP, POP, Twin picture or off mode.
GG
pp..5588--6611
Changes the PIP channel.
GG
pp..5599
Select the connected input source for the sub-picture.
GG
pp..5599
Exchange the main/sub images.
GG
pp..6600
Adjust the factory preset picture depend on the viewing environment.
GG
pp..6699
Select the appropriate type of sound for type of program.
GG
pp..8800
Display information at the top of the screen.
GG
pp..9977
Control video cassette recorders or DVD players.
Move the Listings Grid forward or backward in 24 hour increments.
Navigate the on-screen menus and adjust the system settings to your preference.
Increase/decrease the sound level.
Tune to the last channel viewed.
Switch the sound on or off.
GG
pp..3388
Select available channels.
Move from one full set of screen information to the next one.
VCR/DVD
control buttons
1_512Ven-Edit1 06/10/11 2:50 PM Page 13