LG Electronics DP280-N DVD Player User Manual


 
38
Troubleshooting
Symptom
No power.
No picture on the LCD
or TV (including video
from another unit).
No sound.
The unit does not start
playback.
No response when but-
tons are pressed.
The Remote Control
does not work properly.
Correction
Plug the power cord into the wall outlet securely.
Recharge the battery.
Connect the video cable into the jacks securely.
Set the MODE correctly.
While you are viewing video from other equipment,
set the MODE to A/V IN mode.
Select a LCD mode other than OFF.
Select the appropriate video input mode on the TV
so the picture from the unit appears on the screen.
Select the correct input mode of the audio receiver
so you can listen to the sound from the unit.
Connect the audio cable into the jacks securely.
Insert a playable disc. (Check the disc type and
Regional code.)
Cancel the Rating function or change the rating level.
” may appear on the screen during operation.
Operate the Remote Control within about 23 ft
(7 m).
Cause
The power cord is disconnected.
The battery is discharged.
The video cable is not connected securely.
The MODE selection is not set correctly.
LCD mode is set to OFF.
The TV is not set to receive DVD signal
output.
The equipment connected with the audio cable
is not set to receive DVD signal output.
The audio cables are not connected
securely.
An unplayable disc is inserted.
The Rating level is set.
Some discs prohibit certain operations.
The Remote Control is too far from the
unit.