Filter
Top Products
Connecting
21
Connecting
2
4. The player scans all available access points or
wireless routers within range and displays them
as a list. Use
W/S
to select an access point or
wireless router on the list, and then press ENTER
(
b
).
If you have security on your access point or
wireless router, verify that the WEP or WPA key
that was entered into the player matches the
router’s information exactly. You need to input the
security code as necessary.
y
WEP security mode generally have 4 keys
available on an access point or wireless
router’s setting. If your access point or
wireless router uses WEP security, enter the
security code of the key “No.1” to connect on
your home network.
y
An Access Point is a device that allows you
to connect to your home network wirelessly.
,
Note
[Manual] – Your access point may not be
broadcasting its access point name (SSID). Check
your router settings through your computer
and either set your router to broadcast SSID, or
manually enter the access point name (SSID) in
[Manual].
[Push Button] – If your access point or wireless
router supports the Push Button Configuration
method, select this option and press the Push
Button on your access point or wireless router
within 120 counts. You do not need to know the
access point name (SSID) and security code of
your access point or wireless router.
5. Use
W/S/A/D
to select the IP mode
between [Dynamic] and [Static].
Normally, select [Dynamic] to allocate an IP
address automatically.
If there is no DHCP server on the network and
you want to set the IP address manually, select
[Static] then set [IP Address], [Subnet Mask],
[Gateway] and [DNS Server] using
W/S/
A/D
and numerical buttons. If you make a
mistake while entering a number, press CLEAR
to clear the highlighted part.
,
Note
6. Select [OK] and press ENTER (
b
) to apply
network settings.
7. The player will ask you to test the network
connection. Select [OK] and press ENTER
(
b
) to complete the network connection.
8. If you select [Test] and press ENTER (
b
)
at step 7 above, the network connection status
is displayed on the screen.
You can also test it on the [Connection Status]
in the [Setup] menu.