Filter
Top Products
2
COMPONENT
Install manual Wall mount anchor 6 units Wall mount screw 6 units
* Component of top wall mount
Top wall mount (assembled with a
mounting bracket for wooden walls)
2 spacers (front) 2 spacers (back) 1 pin for fixing top wall
mount
Hanger 2 screws for attaching the hanger
(M6 x L33 mm)
* Component of bottom wall mount
1 bottom-right wall
mount
1 bottom-left wall
mount
2 bottom wall attaching
brackets
2 bottom wall attaching
washers
8 washers
Read these instructions. Keep these instructions.
Heed all warnings. Follow all instructions.
This wall mount should be installed by a trained
and experienced installer designated by the
retailer.
Having the product installed by a non-
specialized installer is very dangerous and can
cause damage or injury.
Do not install the product where the weight
cannot be supported.
If the strength of the location where the wall
mount is installed is not strong enough, it can
fall off and cause an injury.
Use a trained and experienced installer to
move or replace the wall mount, if needed.
Installation requires special techniques. Moving
or installing the product on your own can cause
serious safety issues.
After installing the wall mount, do not hang
on the product or apply severe impact to the
product.
The product can fall off and cause injury.
When installing the wall mount, never hang the
power or signal cable on the rear side the TV.
The cord can be damaged and cause a fire, an
electric shock, or damage to the product.
Install the product according to the
directions in the user manual.
If the product is not installed based on the
directions in the user manual, it can cause a
serious injury or damage to the product.
When installing the product or adjusting the
height of the product after installing, always
do so with 2 people.
Working alone can cause the product to fall off
and result in injury or damage to the product.
During the installation, check the type of wall
material and use the sealed anchor and
screw if the conditions comply.
If you do not use the designated anchor or
screw, the mount may not be able to withstand
the weight of the product and cause a safety
issue.
When drilling holes in the wall, always use a
drill bit and drill of designated diameter. Also
follow the designated directions for the
depth of the hole.
If the product is installed without following the
designated method, the product may be
unstable and cause a safety issue.
Do not wipe the product with a wet towel and
do not use any heater or humidifier below
where the product is installed.
If water flows into the product or if moisture and
heat are applied to the product, it can cause a
fire, an electric shock, or problem to the product.
Do not install the product near any object
that may cause vibration.
Do not install the product near any high
voltage power cable or power source.
Unplug the power cord from the power outlet
before installing the product.
If you install the product with the power cord
plugged, it can cause an electric shock or a fire.
Do not install the product with bare hands.
Always wear proper work gloves.
It can cause an injury.
Do not allow the video connectors connected
to the display to press against the wall. Use
the included right-angle adapters if needed.
Only use attachments/accessories specified by
the manufacturer.