Filter
Top Products
8
5
How to Install the Bottom Wall Mount
How to Select the Installation Location of the Bottom Wall Mount
[unit : mm]
➊
➋
➍
➌
➊ Place the box on the bottom center of the attached top wall mount and place the box at a right
angle (90 degrees) to the top wall mount as shown in the figure.
➋ Find the V on the bottom of your box, and mark the point facing it on the wall [(a) in the figure].
➌ Rotate the box 90 degrees counterclockwise, making sure that (a) point in the figure is always at
the center.
Find the H on the left side of your box and mark the point facing it on the wall.
➍ Move the box to the right. Check if the box is level, using a level.
Find the V on the right side of your box, and mark the point facing it on the wall.
→ Bottom wall mounts should be placed on the points marked in step
➌ and ➍.
Please follow the below direction.
Wall mount screw
bottom wall attaching
brackets
Washer
→ Fix the two bottom wall mounting brackets onto the wall using the wall mount screw as shown in
the figure.
→ Depending on the condition of the wall, use additional washers when tightening the bottom wall
attaching brackets.
a. Locate and mark the centers of the wall studs using a stud finder.
b. After aligning the wall bracket on the wall where the center of the wood stud is marked, mark the
location of the screws and then remove the wall bracket.
c. Use a level to make sure your screw marks are level.
d. Use the 4 mm drill bit for wood to drill holes with the depth of 76 mm or above where the wall mount
screw location is marked on the wall.
e. Clean the drilled hole.
f. Tighten the wall mount screws for the wall bracket on the drilled hole.
→ Depending on the condition of the wall, use additional washers when tightening the bottom wall
attaching brackets.
→ At this time, tighten the screw so that the wall, wall bracket and the wall mount screw are pressed
against one another.
(Drywall can be damaged when tightened with excessive force, please be careful.)
→ When tightening the screw use the + driver (manual or motorized) or 8 mm wrench.
6
- Two or more people are needed to lift and install the product.
Hang the hanger on the top wall mount as shown in the figure.
→ Two people must lift the TV set attached to the hanger and carefully check from both sides whether it
is properly installed.
→ Make sure that the product is fixed securely by lightly pulling on the bottom of the TV.
→ The product should be about 10 mm apart from the wall. When connecting cables and accessories, make
sure that the product is installed at a sufficient distance from the wall to avoid putting stress on them.
→ Pushing the product with excessive force may cause damage to the product.